1/22/2024 0 Comments Homemade barb wire roller![]() ![]() Works great and you're only out the old piece of pipe. Throw pipe and all away, or sometimes you can get pipe back out to reuse. Jab end of pipe in ground, wrap wires around old bolt and start winding. Blow another hole in it about half way and stick an old bolt through it. Posted 19:27 (#3601213 - in reply to #3601092) Subject: Re: Thinking of making a wire winder to go on post hole digger for rolling up old barb wireįind a piece of pipe that fits over the shaft on your digger and blow holes in it so you can pin it on like any other attachment. Have you seen one work? Tried googling wire dawg but all that comes up is the youtube videos. Posted 19:24 (#3601199 - in reply to #3601092) Subject: Re: Thinking of making a wire winder to go on post hole digger for rolling up old barb wire Posted 18:57 (#3601092 - in reply to #3601029) Subject: Re: Thinking of making a wire winder to go on post hole digger for rolling up old barb wire Has anyone else done this or have a better idea? Then just pick roll up with the grapple and haul off. Then once it is rolled up you could just lift the digger straight up and away from the roll of wire. Thinking you could tie all 5 strands on at once. Was thinking of making it cone shaped so you can tie the wire on it and set on ground and start rolling. Thinking of making an attachment to go on my skid steer posthole digger. The wire is no good so no need to save it. I have some old barb wire to roll up that was around a crp patch that is no longer in the crp program. Posted 18:40 (#3601029) Subject: Thinking of making a wire winder to go on post hole digger for rolling up old barb wire Thinking of making a wire winder to go on post hole digger for rolling up old barb wire Jump to page : 1 Now viewing page 1 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |